Drawing Editor - Set Margins on a Drawing

(New: 09/21/01)

 

Margins can be revised on any Drawing to allow that Drawing to fit better on a page.

 

 

1.      Open your building file.

2.      When the job opens up, the Drawing List dialog box will appear on the screen.

3.      Select the Drawing you wish to modify the Margins on.

4.      Print Preview the plan to view the current margin setup.

5.      Select the Revise Button.

 

 

 

 

 

1.      Adjust your Margins of the Drawing to fit better inside the border.

Note: The margins are in Feet/Inches/Sixteenths format. The margins can be a negative number if required.

 

2.       Click on OK

3.       Re-select this drawing to refresh the screen.

4.       Go back to Print Preview to view the drawing.

5.          If the drawing is not at the desired settings repeat steps at 5.